Solder & assembly inspection
Electronics & PCB inspection
A solder bridge caught at functional test costs you a rework station. You're in the field; you lose the customer. We test every board before it goes to test.
Electronics & PCB
A solder bridge caught at functional test costs you a rework station. You're in the field; you lose the customer. We test every board before it goes to test.
- Check solder joint, bridge & paste volume
- Presence of component, polarity & offset
- Silkscreen, serial number and barcode inspection
CellMulti-angle RGB dome with coaxial and low-angle rings · telecentric lens · conveyor-triggered on board-present
Where the money is
Defects surface at end-of-line functional test
Every board judged before it reaches test
Pays back through: test-stage failures, rework labour and field returns.
Your rupee figure is modelled from your own scrap, rework and warranty numbers during Assess & Feasibility.
| Board ID | Inspection result | Severity |
|---|---|---|
| PB-4417-02 | Solder bridge (U3) | Critical |
| PB-4417-05 | Missing capacitor C14 | Critical |
| PB-4417-08 | Tombstoned R22 | Level 2 |
| PB-4417-11 | Insufficient paste | Level 1 |
| PB-4417-14 | Reversed diode D2 | Critical |
| PB-4417-17 | Pass — all nets | None |
Illustrative output. Detection performance is measured on your parts during feasibility.
Start here
Send us the component.
We will let you know if it is visible.
Send 30-50 samples of your good parts, your failure modes. We do imaging trials, train a model, and come back with what we measured, including the cases where the answer is no.